Forums Read-only archive

sip messagenet on brekeke

11 posts · Brekeke PBX Forum

miami71it Original post
1. Brekeke Product Name and Version:
last version


2. Java version:
last

3. OS type and the version:
win 10

4. UA (phone), gateway or other hardware/software involved:

5. Your problem:

hello everyone, I have a sip line with messagenet manager, and a Brekeke PBX latest version
how can i configure the incoming/outgoing sip line on brekeke? I've never done this until now I've used audiocodes with analog lines
thank you
Harold
If the Messagenet manager can send SIP-REGISTER, add the SIP user in the Brekeke PBX.

If you want to use the messagenet manager as a SIP trunk, configure Brekeke PBX's ARS to connect to the Messagenet manager.
https://docs.brekeke.com/pbx/ars-tutorials-samples
miami71it
hi thanks for the answer
yes I would like to configure it as a trunk, I have already configured it with 3CX and it was very simple but with brekeke it is more complex the data available to me are:

Your new telephone number is: +39 1234567 (invented number for example)


URI (SIP Client Identifier) 5**********
Password **********
SIP Server sip.messagenet.it:5061

at this point I have to enter these data in ARS, but I didn't register, I did this

Register URI: sip:sip.messagenet.it:5061 (I also tried removing 5061)

Proxy Address: sip.messagenet.it:5061 (I also tried removing 5061)

User: 5**********
Password: *********

but it doesn't register
what am I doing wrong?
miami71it
sorry in Register URI I wrote wrong the correct wording is: 5**********@sip.messagenet.it:5061 (I also tried removing 5061)
Brett
Hi,

It looks your Register URI is wong.

I think it should be like,
sip:5xxxxxx@sip.messagenet.it:5061

Thank you
miami71it
I tried in every way, even as you suggest, but the answer is always this:
Register failed (403 SIP/2.0 403 Forbidden) - sip:5***********@sip.messagenet.it:5061

the credentials are correct, on a 3CX PBX it works perfectly
Brett
Hi,
Please check the following points.

- On the server where brekeke is running, the domain "sip.messagenet.it" can be resolved properly.

-If the node "sip.messagenet.it" is located on public, you may need to set public address at [SIP SERVER] > [Configuration] > [System] >[Network].
miami71it
from the PC where brekeke is installed I ping sip.messagenet.it and replies OK so he sees it.
I don't understand what you mean, I can't set a public IP on the network otherwise the phones will no longer see the switchboard brekeke
but sorry i don't understand, why in 3CX it's so trivial to configure a messagenet trunk with unser and password and in brekeke it must be impossible°? what's different?
miami71it
ideas?
Brett
Hi,

You don't have to set a public IP on the network interface of the server, but at the Webadmin tool > [SIP SERVER] > [Configuration] > [System] > [Network] >[Interface address 1], set your gateway address(public IP) that communicates to sip.messagenet.it.


If your problem still exists, I recommend you ask brekeke tech support.
miami71it
hello thanks but on interface 1 I have the switchboard ip, if I change it the phones no longer see the switchboard.
can i use interface 2?