Connectting Brekeke PBX to A Session Boarder Controller

1. Brekeke Product Name and Version:Brekeke PBX, Version 3.5.3.3

2. Java version:

3. OS type and the version:Windows server 2012

4. UA (phone), gateway or other hardware/software involved: Blox SBC

5. Your problem: i am having trouble getting brekeke to send and receive calls from and to the sbc.

Do you still have the problem if you don't use the SBC?

sorry for the log delay i had to out of town for business.
i have gotten the sbc to register ext to pbx and make calls. now i need to get the brekeke to accept incoming calls from ITSP trough the sbc and Send calls to ITSP though the sbc. how can i do that using ars and dial plan

Have you tried Brekeke PBX without the SBC?

yes

i can setup to work with out the SBC but i would like to have it in line.

Does the SBC work as outbound proxy? so do you need to specify SBC's IP address as SIP destination?

yes it dose kinda.
i am useing Blox SBC

Have you made ARS for connecting to the ITSP ? Does it work without the SBC?

that is where i am now stuck is gettinng the ars config

Have you looked at this wiki page?
http://wiki.brekeke.com/wiki/Setup-for-Connecting-ITSP

thank you janp i have looked at the wiki page
what i need is for the brekeke to accecpt calls comming from 123.23.1.1 with out auth then to send calls to same address when 9 is dialed

For disabling the auth if an INVITE is sent from 123.23.1.1, add this DialPlan rule in the top of the DialPlan page.
[Matching Patterns]
$request = ^INVITE
$addr = 123.23.1.1$

[Deploy Pattern]
$auth = off
$continue = true


For sending a call to 123.23.1.1 when 9 is dialed, add ARS route in the PBX.

thank you
the problem was resolved with the help of the itsp.

great!