Stop PBX pass thru #8 call park

1. Brekeke Product Name and Version:

2. Java version:

3. OS type and the version:

4. UA (phone), gateway or other hardware/software involved:

5. Your problem:
Network Setup: IP Phone --->V3 PBX --->V2 PBX --->SIP Carrier
IP Phones use


When a user in V3 enters #8 on ip phone endpoint Both v3 and v2 act on it. Is there a way to prevent the pass thru of #8 from v3 pbx to v2 pbx. Using rfc2833 for dtmf because carrier requirement. Thanks!

Is it possible to change the built in key for call park to something other than #8? #5 for example?

This is not official way but you can add a property like below at Options > Advanced.

fw.com.brekeke.pbx.fw.talker.User.COMMAND_TRANSFER=DTMF:#9;TIME:1500;COMMAND:TRANSFER,DTMF:#5;TIME:1500;COMMAND:PARK2,DTMF:#0;TIME:1500;COMMAND:CONF,DTMF:#7;TIME:1500;COMMAND:CONF_SILENT


It would not be better to apply a PBX user to the calls at V2 PBX so the call won't be parked at V2 PBX.

Lucy

Lucy,

Thank you very much for your response. Can i use this string in either v2 or v3?

For others reading this post i reformatted the answer to make it easier to read. It appears the commas are the delimiter.

Park changed from #8 to #5:

fw.com.brekeke.pbx.fw.talker.User.COMMAND_TRANSFER=
DTMF:#9;TIME:1500;COMMAND:TRANSFER,
DTMF:#5;TIME:1500;COMMAND:PARK2,
DTMF:#0;TIME:1500;COMMAND:CONF,
DTMF:#7;TIME:1500;COMMAND:CONF_SILENT