Forbidden message 403 from ITSP

1. Brekeke Product Name and version:2.4.7.3/286.1

4. UA (phone), gateway or other hardware/software involved:
Xlite

5. Select your network pattern from http://www.brekeke-sip.com/bbs/network/ ... terns.html : pattern 8

6. Your problem:
I'm using SIP server to send calls to a voip carrier which accepts calls through IP authentication.so traffic is going to voip carrier in following way:
Xlite >> Brekeke SIP server >> voip carrier

also i'm using this dial plan in my sip server:

[matching pattern]
$request=^INVITE
To= sip:00(.+)@

[deploy pattern]
To= sip:%1@CARRIER_IP_ADDRESS

Unfortunately calls rejected from my carrier,Wireshark shows me my carrier sends Forbidden message 403 .
Also I decided to make sure about my carrier to accepts my calls so I tested with my quintum gateway in following way

ISDN >> quintum >> carrier

And it worked for me ,connection established without any error message.I set the quintum register expire time= -1 (means no registration required).

Also I tested my sip server with another voip carrier (voipms).It worked for me too.

But I have problem with my main voip carrier which accept calls though ip authentication.

Any help to solve this problem.
Thanks

Set the [B2B-UA mode] = "on" at the [Configuration] > [SIP] page.
It may solve the issue.

B2B-UA Mode turned on but the problem is still there and was not solved.

another thing I want to mention is when i tried to send my calls using Quintum(ISDN>> quintum >> voip carrier) and see my call log, every time calls routed to voip carrier it uses a new ip address of my carrier.It seems carrier reply the sip with new Ip address.

Maybe it can guide you well.

if you connect X-Lite to the carrier directly , does the same issue happen?

Carrier accepts calls using IP authentication so X-lite can't communicate with the my voip carrier because x-lite needs username and password to be registered with server.

But when using quintum to send call to my carier it doesn't have problem.

I guess my carrier can't accept my contact URI because it is different with my "From" section of my dial plan.

My sip server has 2 ip addresses(one public and one private).
Contact URI when calls going out is the private one but "From" contains public IP .
How can i change contact URI to the same as From ip address.

I tried following dial plan but it doesn't works

[Matching pattern]
$request=^INVITE
To=sip:00(.+)@

[Deploy pattern]
To=sip:%1@VOIP_carrier_IP address
From=sip:annonymous@MY_SERVER_PUBLIC_IP
Contact=%1@MY_SERVER_PUBLIC_IP

It is still shown my private ip address in contact URI when capturing by WireShark.

> Contact URI when calls going out is the private one but "From" contains public IP .

It seems you didn't configure the SIP Server correctly.

Put MY_SERVER_PUBLIC_IP in the [Config] page's Interface settings.

You don't have to define "Contact" in the Deploy pattern.

Thanks.I solved that problem by disabling one of my extra NIC.

Thanks again