Port problem for registration with Brekeke PBX

Dear All
I want to register a user suppose '101' with Brekeke PBX using sip port 1079 and then Brekeke PBX will register the user with another sip server which is using sip port 5060.

How can i do that?


Note:
when i use 5060 sip port in Brekeke PBX it works fine but if i use 1079 it doesn't work

did you try to set port 1079 after SIP server address at phone side, like sip_server_ip:1079

Yup i tried with it. But doesnt work.

How do the REGISTRATION packets and the response packets look like?
Can you try capturing the packets and past them here?

what do you mean by the REGISTRATION packets and the response packets ?

hi

did you put 1079 in [Local Port] setting at Brekeke SIP Server?
(Configuration -> SIP -> SIP exchanger )

Use some tool to monitor the SIP packets
http://www.brekeke-sip.com/wiki/index.p ... i=f4b972a2

did you change SIP port from brekeke sip server/configuration/SIP/ local port? or you also change something else?

What is "another sip server which is using sip port 5060" when you registered phone to sip port 1079?

@Hope

I've changed sip port to 1079 from sip server/configuration/SIP/ local port.


The another sip server which is using sip port 5060 is Cordia. It's a private Sip server.
Someone have idea on it?

if you turn off the other SIP server(Cordia), can you register the phone to brekeke pbx with port 1079?

Ya I can register with Brekeke using sip port 1079 if i don't use Cordia.

I think i need to set a dialplan for that.